Publicité
1
Ready...let's start!
Before playing, an adult must install fresh alkaline batteries in the
Light-Up module (part D). Here's how:
1. Using a Phillips screwdriver (not included) remove the screw and
battery compartment cover from the Light-Up module (part D).
2. Install three (3) fresh 1.5V AA (LR6) alkaline batteries (not included),
making sure the (+) and (-) ends face the proper direction as indicated
inside the battery compartment.
3. Replace the compartment cover and tighten the screws.
1.5V AA/LR03
Battery installation MUST be
completed by an adult:
1.5V AA/LR03
1.5V AA/LR03
Modes
D
Modes
1. Combination
2. In Wave
3. Sequential
4. Slow Glow
5. Chasing/Flashing
6. Fade
7. Flash/Twinkle
8. Steady on
9. O
ON
OFF
6
Tool required (not included)
Publicité
