Maintenance - Veripart VPSB103 Manuel D'instructions

6. MAINTENANCE

Check the hose, dust collector and filters regularly to prevent any problems. If the hose is
clogged, empty it. Empty the dust collector when it is full and clean or replace the filters
when they are dirty.
Emptying the dust collector
On the dust collector you will find a maximum indication max fill [a]. Empty the dust
collector when the amount of dirt reaches the maximum indication.
1. Grab the handle of the dust collector and press the button [b] to
release the dust collector. Lift the dust collector.
2. Hold the handle of the dust collector while holding it above a dust bin.
Press the button [c] to open the bottom of the dust collector. The bottom
lid opens automatically and releases the dirt in the dust bin.
3. To fully empty the dust collector, calmly shake it above the dust bin.
4. Close the bottom lid of the dust collector. You will hear a click when the
bottom lid is closed correctly.
5. Place the dust collector back on the vacuum cleaner. You will hear a
click when it is placed correctly.
Cleaning the cyclone filter
The filters play an important part in the efficiency of the vacuum cleaner. When the filters are
clogged the performance will decrease. Therefore cleaning or replacing the filters frequently
is essential. Clean the cyclone filter every six months.
1. Grab the handle of the dust collector and press the button [b] to
release the dust collector. Lift the dust collector.
2. Pull the clip [d] forwards and open the lid of the dust collector.
3. Pull the cyclone filter [e] out of the dust collector by the rubber edge.
4. Clean the cyclone filter [e] under lukewarm water. Do not use any
cleaning agents or brushes.
Cleaning the filter will remove the dirt, but will not restore the original
white color of the filter. The color of the filter is not of any influence to
the performance.
5. Press a much water as possible out of the cyclone filter and let it air
dry completely for at least 24 hours.
Attention: using a damp cyclone filter could cause damage to the engine.
6. Press the cyclone filter back in the dust collector.
7. Close the lid of the dust collector. You will hear a click when it is closed correctly.
8. Place the dust collector back on the vacuum cleaner. You will hear a click when it is placed
correctly.
2 3
b
d
c
a
d
e