Using Your Nature's Generator; How To Recharge Your Nature's Generator - Nature's Generator GXNGPT-PE Mode D'emploi

Using Your Nature's Generator

How to Recharge Your Nature's Generator

Recharging from Solar Panels
1. Place your solar panel where it will get as much direct sunlight as possible. While direct sunlight
in always preferred, solar panels should be connected at all times to provide a consistent trickle
charge to your battery. Solar panels will also send a charge to your unit while in hazy or overcast
skies.
2. Insert solar panel plug into Solar Input port on the front of your Nature's Generator. You will know
it is recharging when LCD display lights up, solar panel icon is illuminated and battery bar starts to
register. The battery bar will stop registering when the battery on the LCD display is full or there is
not enough power from solar panel.
3. It takes about 10 to 15 hours to recharge Nature's Generator if using 100 watt solar panel, and
also depends on the the strength of the sunlight.
4. To increase the recharging speed, you can daisy chain multiple solar panels in parallel connection.
The Solar Input port can handle up to 200 watts of solar power. Visit Naturesgenerator.com for
information on purchasing additional solar panels.
Recharging from the Wind Turbine
1. Place your wind turbine where it will get as much wind as possible.
2. Insert wind turbine plug into Wind Input port on the front of your Nature's Generator. You will
know it is recharging when LCD display lights up, wind turbine icon is illuminated and battery bar
starts to register. The battery bar will stop registering when the battery on the LCD display is full or
there is not enough power from wind turbine.
3. The recharging speed depends on the wind turbine power rating and the strength of the wind.
The Wind Input port can handle up to 300 watts of wind power. Visit Naturesgenerator.com for
more information about the wind turbine.
Recharging from AC Power
1. Locate the power cord in the rear storage compartment on the back of the Nature's Generator.
2. Insert the power cord to the AC Input Port on the front of the Nature's Generator.
3. Plug the other end of the power cord into the wall outlet. You will know it is recharging when LCD
display lights up, AC input icon is illuminated on the LCD display and battery bar starts registering.
The battery bar stops registering when the battery is full.
6
Visit Naturesgenerator.com for More Information