System Configuration; Creating The Account; Rf Configuration (Receiver - Thermostat) - Ferroli CONNECT Notice D'installation Et D'utilisation

5.3 system configuration
To allow proper operation with your device (Tablet or smartphone), proceed as follows:
• Download the App (COИИECT) directly from the App Store of your device or using
the QR CODE on the outside of the package.
• After installation, create the account.
5.3.1

Creating the account

• Make sure your SMARTPHONE/TABLET device is connected to the Wifi network.
• Open the dedicated APP, and click on "Register".
• Enter the requested data and press code verification.
• To confirm the registration, enter the code received via the email previously entered.
To manage the boiler from several users, enter with the same account.
5.4 rf configuration (receiver - Thermostat)
To establish the RF connection between the thermostat and the receiver, proceed as
follows:
• Press the receiver LED button until it flashes (about 7 seconds).
• In the thermostat keep the "set"
display flashes.
• Press the button
• When the message "r01, r02..÷..r08" appears, the connection has been made. Press
"set" " again.
Note: Data exchange between thermostat and receiver occurs within 2 min-
utes
" button pressed for a few seconds until the
until displaying
cod. 3541S181 - Rev. 01 - 04/2021
and press "set" ".
41
EN