BRC HYGIPOST Manuel D'instructions page 2

HYGIPOST
INSTRUCTION MANUAL
You have just purchased a gel dispenser, we
hope it will give you complete satisfaction.
Can plate adjustment
Assembly screws
Loosen the assembly screws, position the can on the
plate, put the top cover in place and lock it.
Position the plate so that the top of the pump is in
contact with the underside of the top cover.
Tighten the assembly screws.
Cans storage
Cans storage
Possibility to store 2 cans on the plates.
BE
Cover lock
Put the cover into the cut-out on the side of the
dispenser, rotate it to close it and then lock it
with the key and remove it from the lock.
Wall fixation
After the holes have been drilled, fix the rear cover
to the wall, position the dispenser on the cover,
tighten the screws on each side, position the upper
cover, lock the assembly and remove the key from the
lock.
Ground fixation
30/06/202 Ind A