Oceanic OCEASFBS2000W Guide D'utilisation page 33

1. Before using this appliance, ensure that it is placed on a flat, stable surface. This
unit is equipped with an anti-tilt device which stops the machine in case it falls
down or if it is not placed on a stable surface.
2. Check that the voltage corresponds to that of the power supply (230V~ mains
socket). Plug in the appliance.
3. This heater is equipped with digital Controls that provide the ability to set the
temperature to the exact degree desired. To operate, simply follow these
instructions.
Note: The display shows the temperature of the area around the product
(diagrams below)
There may be a difference of temperature indication, between the heating zone
and the room. This difference is reduced during a continuous operation of the
heater.
Note: The temperature display will not reflect the accurate room temperature until
the heater has been operating for at least 30 minutes.
4. Place the product in a vertical position on a flat, stable, heat-resistant surface.
Using the device in any other position could cause danger. Make sure there are
no flammable or heat-sensitive products near the unit.
5. Insert the mains plug into a suitable wall socket. Press
control panel of heater or
product.
To turn off the heat, press this button again. Ventilation will continue for 15
seconds to cool the interior of the unit before shutting down completely.
on the remote control to turn on the
on the
33