GALA Sensitive Smart Manuel D'instructions Et D'utilisation page 59

TURN OFF AUTOMATICALLY
So as to make the equipments life cycle
longer, this remote control has a "turn off
automatically" system. If you are 20 seconds
without touching the remote control screen or
without activating a function, the device will
turn off itself automatically.
FINAL BLOW
The bathtubs equipped with AIR
hydromassage activate the "final blow" , which
cleans the correspondent conducts. This blow
is only carried through when the bathtub is
empty and the remote control is deactivated,
in the next half an hour after the
hydromassage use or the disinfection action.
WARNING SIGNAL OF MINIMUM WATER
LEVEL
When filling the bathtub, when the water
level exceeds the highest injector, bathtub
emits an audible signal, indicating that the
water level is enough for the hydromassage
system to work.
WARNING SIGNAL OF WATER
TEMPERATURE
When the water temperature in the bathtub is
superior to 50ºC, the bathtub will make a
sonorous signal and it will appear a danger
sign next to the temperature. All bathtub
functions will be blocked until the
temperature decreases to 40ºC.
LOW BATTERY SIGNAL
When initiating the remote control if the
symbol shown above appears it means that
the battery is low and it must be replaced.
The remote control will continue functioning
but the retro illumination will be turned off in
order to spare the batteries.
BATTERIES CHANGE
AAA
If the low battery sign appears in the screen
replace the batteries of your remote control.
The batteries to be used are two AAA
batteries, and you should proceed this way:
• untwist the screws and remove the back
cover of the remote control.
• remove the two AAA batteries and place
new ones, in the position indicated in the
picture above.
• make sure that the sealant is well placed,
because this will guarantee the remote
control estanquicity.
• put the cover back in its place and screw it
back.
• touch the screen to initiate its use.
• if at the end of 15 seconds the temperature
is kept in 0ºC, you must initiate the
synchronization process..
57