Vemer ADR-Series out Manuel D'utilisation page 43

Note: if the voltage V or the current I are >999, the words "Voltage"
and/or "Current" will flash to indicate that the measurement unit
is not complete (the prefixes 'k' or 'M' are missing)
3) Phase voltage page
VOLTAGE
3
• The phase voltages are displayed.
If the three phase system has no neutral, the voltages refer to a fictitious
star delta centre
• Press "T" to display the system voltage page
3a) Phase voltage peak value page
VOLTAGE
V
1
3 2
• If the "pK" is pressed repeatedly from one of the two phase voltage pages,
the following are displayed in order:
- the voltage peak values (phase or system), with the "V" measurement
unit flashing
- the instant when the peak occurred (time and date flashing if the clock
has not yet been set)
- the number of hours lapsed between the start-up of the instrument
and the occurrence of the peak, in hours and tenths of one hour
• Press "up" ( ) at any time to go to the next page
➧
V
1
2
T
➧
pK
VOLTAGE
V
User Manual ADR-out Network Analyser
VOLTAGE
V
➧
pK
h VOLTAGE
- 41 -
pK
pK
h
T