Publicité
Les langues disponibles
Les langues disponibles
Liens rapides
When using electrical equipment, basic safety precautions should always be followed including the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
1.
DANGER- Risk of shock- Disconnect power before installation.
DANGER – Risque de choc – Couper l'alimentation avant l'installation.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE
TO INSTALL:
1
Small Flood
INSTALLATION
STEP 1:
Remove the (4) Phillips head screws on the back of the luminaire and discard screws. See Figure 1.
STEP 2:
Place the visor onto the back of the luminaire, aligning the screws included with the visor accessory with the holes in the luminaire. Tighten screws to
20 in-lbs (2.2 N·m)
© 2019 Cree, Inc. All rights reserved. For informational purposes only. Content is subject to change.
See http://lighting.cree.com/warranty for warranty and specifications. Cree
Cree, Inc.
1 of 1
IMPORTANT SAFEGUARDS
and the Cree Logo are registered trademarks of
®
NTF Series
LED Flood Lights
INSTALLATION INSTRUCTIONS
INSTRUCTIONS D'INSTALLATION
Large Flood
LPN00638X0001A0_A
Visor
lighting.cree.com
Publicité
Manuels Connexes pour Cree NTF Serie
Sommaire des Matières pour Cree NTF Serie
- Page 1 Place the visor onto the back of the luminaire, aligning the screws included with the visor accessory with the holes in the luminaire. Tighten screws to 20 in-lbs (2.2 N·m) © 2019 Cree, Inc. All rights reserved. For informational purposes only. Content is subject to change. See http://lighting.cree.com/warranty for warranty and specifications. Cree and the Cree Logo are registered trademarks of ®...
- Page 2 Placez la visière à l'arrière du luminaire, en alignant les vis fournies avec celle-ci et les trous du luminaire. Serrez les vis à 2,2 Nm (20 po-lb) © 2019 Cree, Inc. Tous droits réservés. À des fins d’information uniquement. Le contenu est sujet à changement.