Cutters Edge 2100 Serie Fonctionnement Et Entretien page 38

37/
CUTTERS EDGE FIRE RESCUE SAWS
THE GUIDE BAR
Remove the guide bar and wipe debris from it.
Clean out the chain groove using a bar cleaning tool
or a putty knife (Fig. 27). If there is excess tar or
debris buildup on the bar, clean it off with solvent.
It is also important to thoroughly clean the oil holes
on both sides of the guide bar. (Fig. 28 )
After cleaning the bar, lubricate the bearings in the
sprocketnose (Fig. 29) with the grease and grease
gun provided with each saw.
When you reinstall the guide bar, flip the guide bar
over so the edge that was on the bottom is now on
the top. This allows even wear to the guide bar rails.
Reference the logo position each time the bar is
reinstalled (Fig. 30)
Fig. 27. Cleaning bar groove
Fig. 28. Cleaning oil holes on guide bar
Fig. 29. Lubricating sprocket bearings
Fig. 30. Reference logo position each time
you reinstall the guide bar.