Publicité
Les langues disponibles
Les langues disponibles
Liens rapides
Bulb Heaters & Bulb Heater/Fans
MODELS: 9417DNM, 9420WHC, 9425WHC
IMPORTANT SAFETY INSTRUCTIONS
WARNING – TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK,
OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:
1. Use this unit only in the manner intended by the manufacturer.
If you have questions, contact the manufacturer at the address
or telephone number listed in the warranty.
2. Before servicing or cleaning unit, switch power off at service
panel and lock service panel to prevent power from being
switched on accidentally. When the service disconnecting
means cannot be locked, securely fasten a prominent warning
device, such as a tag, to the service panel.
3. Installation work and electrical wiring must be done by a quali-
fied person(s) in accordance with all applicable codes and stan-
dards, including fire-rated construction codes and standards.
4. Sufficient air is needed for proper combustion and exhausting
of gases through the flue (chimney) of fuel burning equipment
to prevent backdrafting. Follow the heating equipment
manufacturer's guideline and safety standards such as those
published by the National Fire Protection Association (NFPA),
and the American Society for Heating, Refrigeration and Air
Conditioning Engineers (ASHRAE), and the local code authori-
ties.
5. When cutting or drilling into wall or ceiling, do not damage elec-
trical wiring and other hidden utilities.
6. Do not install this unit over a tub or shower.
7. Never place a switch where it can be reached from a tub or
shower.
8. Do not operate unit with dimmer switch or speed control.
CAUTION
1. For general ventilating use only. Do not use to exhaust haz-
ardous or explosive materials and vapors.
2. This product is designed for installation in flat ceilings only.
DO NOT MOUNT THIS PRODUCT IN A WALL.
3. To avoid motor bearing damage and noisy and/or unbalanced
impellers, keep drywall spray, construction dust, etc. off power
unit.
4. Please read specification label on product for further informa-
tion and requirements.
INSTALLATION INSTRUCTIONS
READ & SAVE THESE INSTRUCTIONS!
PLAN THE INSTALLATION
Choose the location for your heater. Refer to Warnings and Cau-
tions.
MODELS 9417DNM & 9425WHC ONLY – The unit will operate
most efficiently when located where the shortest possible duct run
and minimum number of elbows will be needed. Units are de-
signed for use with standard 4" round duct.
Note that two-bulb units can be fitted with one infrared bulb (for
heat) and one reflector bulb (for light). Dual or multi-controls can be
used for separate control of bulbs and/or exhaust fan. Purchase
controls separately.
Refer to FIGURE 1
Follow these basic steps when installing this unit:
1. Nail unit to joists.
2. Attach ductwork (Models 9417DNM & 9425WHC only).
3. Connect power cable.
4. Fasten grille to housing.
PREPARE THE HEATER
1. Remove the unit from carton. Save carton for use as plaster
shield in rough-in installations.
Refer to FIGURE 2
2. Slide adjustable mounting brackets into bracket channels on
housing.
DAMPER/DUCT
CONNECTOR
CEILING
JOIST
CEILING MATERIAL
1
POWER CABLE
MOUNTING
HOUSING
GRILLE
BULB(S)
FIGURE 1
FIGURE 2
BRACKET
Publicité
Manuels Connexes pour NuTone 9417DNM
Sommaire des Matières pour NuTone 9417DNM
- Page 1 OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: MODELS 9417DNM & 9425WHC ONLY – The unit will operate 1. Use this unit only in the manner intended by the manufacturer. most efficiently when located where the shortest possible duct run If you have questions, contact the manufacturer at the address and minimum number of elbows will be needed.
- Page 2 5. Install BR40 or R40-size 250W infrared bulb(s). Center grille around bulb(s). USE AND CARE MODELS 9417DNM & 9425WHC OPERATION NOTE: These units are designed with a thermostat which senses excess heat and may start the blower automatically. This is normal and is no cause for concern.
- Page 3 GROUND BLACK VENT BLACK BLACK DUAL CONTROL 120 VAC LINE IN 120 VAC LINE IN MODEL 9417DNM MODEL 9417DNM Lamp & Vent operate together Lamp & Vent operate separately BLACK to BLACK, & YELLOW RED to RED WHITE to WHITE to...
- Page 4 TO, IMPLIED WARRANTIES OR MERCHANTABILITY OR FIT- NESS FOR A PARTICULAR PURPOSE. During this one-year period, Broan-NuTone will, at our option, repair or replace, without charge, any product or part which is found to be defective under normal use and service.
- Page 5 AVERTISSEMENT – POUR RÉDUIRE LES RISQUES D’INCENDIE, DE MODÈLES 9417DNM ET 9425WHC SEULEMENT – L’appareil sera plus CHOC ÉLECTRIQUE OU DE BLESSURE, VEUILLEZ OBSERVER LES efficace s’il est raccordé à un minimum de conduits et de coudes. Il est CONSIGNES SUIVANTES : conçu pour être utilisé...
- Page 6 Installez une ou deux lampes à infrarouge BR40 ou R40 de 250W. Centrez la grille autour des lampes. UTILISATION ET ENTRETIEN FONCTIONNEMENT DU MODÈLES 9417DNM ET 9425WHC: Ce modèle comporte un thermostat pour détecter les excès de chaleur et actionner automatiquement le ventilateur. Il s’agit d’un fonctionnement normal et il n’y a pas lieu de s’en inquiéter.
- Page 7 TERRE TERRE NOIR VENT. NOIR NOIR COMMANDE DOUBLE ENTRÉE ENTRÉE 120 VCA 120 VCA MODÈLE 9417DNM MODÈLE 9417DNM Lampe et ventilateur Lampe et ventilateur fonctionnant ensemble fonctionnant séparément ROUGE au BLANC au BLANC au ROUGE NOIR au BLANC / GRIS...
- Page 8 IMPLICITES, Y COMPRIS, NOTA M M E N T, LES GARANTIES IMPLICITES DE QUALITÉ MARCHANDE OU D’ADÉQUATION À UN USAGE PA RTICULIER. Pendant cette période d’un an, Broan-NuTone, à son choix, réparera ou remplacera gratuitement tout produit ou pièce s’avérant défectueux dans des conditions normales d ’...