Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
Fax +32 030 9904733
Place main unit (A) on a horizontal supporting surface that is stable and washable.
1.
Place the jug (F) on the main unit and make sure that:
-
the silicone seal is fully seated into the slot of the drain spout (see figure)
-
the 3 pins and slots fit
-
the line shown on the mouth and the dot on the power unit meet, as in the figure.
2.
Insert the filter (H) into the filter holder (G) until you hear a click signalling the correct
insertion, and make sure that the 2 silicone spatulas in the filter holder are attached properly and
that they wipe the perforated parts
3.
Next, insert the two parts inside the jug and make sure the arrow "▼" on the edge of the filter
lines up with the dot "●" screen printed on the upper edge of the jug.
4.
Position the juicing screw (I) in the filter and engage the hollow pin with the motor pin: press
the screw and simultaneously rotate slightly to make sure that the screw is fully housed.
5.
Close the jar with the lid (L) and make sure that:
-
the lid is tight to the edge of the jug
-
the arrow "▼" of the lid is aligned with the dot "●" of the
upper edge of the jug. Turn the lid clockwise so that its
edge goes into the slot and the two symbols " " of the
appliance lid are aligned, as shown in the figure. In this
way, the safety switch will activate the motor.
6.
Attach the juice jug (N) to the main unit below the juice outlet spout (E).
7.
Attach the jug (C) to the unit and below the pulp outlet spout (D).
USE
The appliance is equipped with:
-
ON-0-R (Reverse) switch: with the button set to "ON", the unit turns on; with the button in
the centre position, the power is off (pos. 0). Pressing the button in pos. "R", the motor rotates
in reverse direction and releasing the button will send the button back to pos. "0".
-
Safety switch: allows operation only if the lid is closed tightly and placed properly (with the
strip inside its guide)
-
Presser for inserting the food to be juiced
-
Juice jug to collect the juice extracted
-
Jug to collect the pulp
-
Cap to close the juice outlet spout
•
Plug into the power point.
•
Press the switch while in pos. "On" to start the motor.
•
Make sure the juice jug and the pulp jug are properly positioned under their spouts; open the
spout cap to release the liquid.
•
Insert the food via the hole in the lid and press it gently but firmly with the presser supplied.
Avoid putting too much food at one time.
•
Do not use the appliance for more than 20 minutes at a time. In the event of blockage during use,
immediately press the button while at pos. "R" (reverse) for a few seconds: the motor will rotate
in the opposite direction and release the obstruction. Repeat this process 2 or 3 times. If the
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't
change the page numbering. Keep the language
integrity.
14/40
Assembly page 14/41
Publicité
