Télécharger Imprimer la page

Learning The Device Codes - BENE :3C! vidision SRC-7000 Mode D'emploi

Table des Matières

Les langues disponibles

LEARNING THE DEVICE CODES.

This function allows Remote Control to learn original remote control codes. Once these codes are learnt, all devices can be

controlled centrally from one single source.

Press

for 2 seconds to enter setup Menu.

Select the „Code Setting" menu and confirm pressing the

Select the „

Learning" key and confirm pressing the

for the learning function. Re-confirm pressing the

Select the menu of the device whose functions you want Remote Control to learn. Before entering this menu you will be

guided through the menu of learning SRC-7000 rubber keys. Skip this menu by activating the „continue...

For the device to learn, point your original remote to the „Learning Eye" (located at the bottom of the SRC-7000) at a

distance of approx. 5-10 cm (see picture on the right). The display shows the key that is learning a specific function

in black.

key.

key to enter the sub-menu. You will see the Help Guide

key after reading all learning steps.

Setup

" key.

PLAY

CH+

VOL-

VOL+

CH-

STOP

Enter