Beurer BY 40 Mode D'emploi page 18

• Remove the mains part plug from the socket when the breast pump is not in use. Do not leave the breast
pump plugged in.
• If the mains cable of the breast pump is damaged, it must be disposed of.
• Never heat up breast milk in the microwave as it may be heated unevenly and could burn your child when
they drink it.
• Keep the mains cable away from hot surfaces.
• This device may not be used by people with reduced physical, sensory or mental skills or a lack of expe-
rience or knowledge, provided that they are supervised or have been instructed on how to use the device
safely, and are fully aware of the consequent risks of use.
• The breast pump does not need calibration.
• No modification to this equipment are allowed.
IMPORTANT
• Never moisten the breast pump with water. It is not protected against water splashes or liquids.
• Keep the breast pump away from strong electromagnetic fields, since electromagnetic interference can
occur and adversely affect the functionality of the breast pump.
• Protect the breast pump and its accessories against impacts, humidity, dirt, marked temperature fluctu-
ations and direct sunlight.
• Do not pull on the breast pump tubes.
• Do not use the mains cable to pull the mains part plug out of the socket.
IMPORTANT
Instruction for Transport of the feeding bottle
• When transporting breast milk in the bottle (e.g. when on the move or travelling), make sure that the screw
plug is always screwed on tightly.
• We recommend not to store the filled bottle into suitcase, bags, etc. during transport.
WARNING
For your child´s safety and health with the feeding bottle
• Always use this product with adult supervision.
• Never use feeding teats as a soother (not included in BY 40).
• Continuous and prolonged sucking of fluids will cause tooth decay (not included in BY 40).
• Always check food temperature before feeding.
• Inspect before each use and pull the feeding teat in all directions. Throw away at the first signs of damage
or weakness (not included in BY 40).
• Do not leave a feeding teat in direct sunlight or heat, or leave in disinfectant ("sterilising solution") for longer
than recommended, as this may weaken the teat. (not included in BY 40)
• Do not tip the teat in sweet substances as they encourage the formation of tooth decay (not included in
BY 40).
• Do not use solvents or abrasive cleaning agents.
• Before first use place the parts which are in contact with milk in boiling water for 5 minutes. This is to
ensure hygiene.
• Clean before each use.
• Make sure that the liquid inside the bottle never exceed 50°C.
18