Review Wheel Assignment Or Reverse; Copy Scanner; Fade Time Assign - Nicols C 512 M Manuel D'utilisation

User manual

3.1.4 REVIEW WHEEL ASSIGNMENT OR REVERSE

Warning: This will reset the controller to its factory defaults.
This will erase all programs and settings.
Action :
1) Press and hold FINE & MODE buttons together one time to access the wheel assignment mode
2) press a SCANNER button to select a scanner
3) Press and hold FINE & MODE buttons together (2) times to exit
Action : (wheel assignment Review)
1) Press and hold FINE & mode buttons together (2) times to access the channel reverse mode
2) press a SCANNER button to select a scanner
3) Press and hold FINE & MODE buttons one time to exit

3.1.5 COPY SCANNER

Example: Copying Scanner 1 into Scanner 2
Action :
1) Press and hold SCANNER button # 1.
2) While holding button # 1 press SCANNER button # 2.
3) Release SCANNER button # 1 first before releasingSCANNER button # 2.
4) All SCANNER LED indicators will flash to confirm successful copy.
Notes : To save time, you can copy the settings of one Scanner button to another.

3.1.6 FADE TIME ASSIGN

You can choose whether the board s fade time during scene execution is implemented broadly to all
output channels or only to the Pan & Tilt movement channels. This is relevant because often you will want
gobos and colors to change quickly while not affecting the movement of the light.
Action :
1) press and hold the PROGRAM button until the led blinks
2) Press and hold FINE & MODE buttons together to access REVERSE mode and REVERSE LED ON,then
press the SCANNER button
3) Use the Bank up/Down buttons to select pan/tilt
4) Press the TAP/DISPLAY button to switch between pages
5) press and hold MODE button,then press the SCENES buttons to select the DMXchannel.All LEDs will
blink.
6) Press and hold FINE & MODE buttons (2)times to exit
3.1.7 FADE TIME ASSIGN
You can choose whether the board s fade time during scene execution is implemented broadly to all
output channels or only to the Pan & Tilt movement channels. This is relevant because often you will want
gobos and colors to change quickly while not affecting the movement of the light.
Action :
1) Turn OFF the controller.
2) Hold the BLACKOUT and TAPSYNC DISPLAY buttons simultaneously.
3) Turn ON the controller.
4) Press the TAPSYNC DISPLAY button to toggle between the two modes. Either all channels(A) or select
channel Pan & Tilt only (P)
5) Press BLACKOUT and TAPSYNC DISPLAY to save settings. All LEDs will blink to confirm.
Notes : A: All channels P: Only Pan & Tilt
All manuals and user guides at all-guides.com
C 512 M
29