Publicité
Les langues disponibles
Les langues disponibles
SENSMICRO
OPERATION INSTRUCTION AND INSTALLATION
ENG
Cod.
Input
SENSMICRO
AC220-240VAC 50Hz
The SENSMICRO model is a switch with microwave sensor (5.8Ghz) that detects the movement in its own
radius of action (360 °) with an adjustable distance from 3 to 10 meters. The microwave sensor can overcome obstacles
like glass panels, doors or thin walls.
~ IN
- Connect L and N to the power (Input)
- Connect A and N to the load (Output)
SAFETY
•
Installation and maintenance must only be carried out by qualified personnel
•
Always switch off the voltage before installing or servicing
•
Place the product in a suitable place for protection class IP20
•
Do not install on an unstable surface
•
Do not disassemble or tamper the product to avoid electrical shocks
•
Do not install near surface subject to high or very low temperatures
IMPORTED BY: LAMPO LIGHTING TECHNOLOGY SRL
Via dell'industria 6, 47832 San Clemente RN ( ITALY )
www.lampolighting.com
This instruction sheet have to be kept for future consultations
Power load
LED 300W, INC 1200W
INSTALLATION
1. Switch off main power
2. Fix the bottom on the selected position with the inflated screw through the
screw holes at the side of the sensor
3. Connect the power and the load to sensor as per the connection-wire sketch
diagram on the left
4. Adjust according to the use of the sensor the lux, sens and time through the 3
side controllers
5. Switch on and test the sensor
• Time-delay (TIME) settable from 10 seconds to 15 minutes
• Distance adjustment (SENS), from a minimum of 1mt to a maximum
•
• Light sensitivity adjustment (LUX), from a minimum of 3 lux to a
maximum of 2000 LUX. Set the controller to maximum to use the
sensor during daylight hours
Detection distance
Time
3-10mt 360°
10 Sec - 15 Min
FUNCTIONS
of 10 meters
Ambient Light
IP
10 - 2000 LUX
20
Light sensor
Operating LED
WWW.LAMPOLIGHTING.COM
made in P.R.C.
Publicité
