Valor GV60BRK Guide D'installation Et D'operation page 5

Remote Control Operation
Setting P2 high and low temperature times.
Repeat same steps as Setting P1.
When all settings are complete, press
Timer Programming Example (default temperatures shown)
6:00 am
P1
high temp
Set temp 74˚F
Automatic Turn Down
1-Hour Turn Down for Special Receiver
The valve will turn to pilot flame if there is no change in
flame height for over a 1-hour period.
Automatic Shut-Off
Low Batteries Receiver.
in the battery holder the system shuts off the fire
completely. This does not apply when the power supply
is interrupted.
On-Demand Pilot (7 Day Shut-Off).
eliminates gas energy consumption during extended
appliance inactivity. When the appliance is inactive for
an extended period of time the system automatically
extinguishes the pilot. This feature helps the consumer
realize cost benefits by automatically eliminating energy
consumption during non-heating months and limited
use.
The programmed length of inactivity to activate the
system is specified by the appliance manufacturer and
cannot be altered in the field.
Because our policy is one of constant development and improvement, details may vary slightly from those given in this publication.
Designed and Manufactured by / for
Miles Industries Ltd.
190 – 2255 Dollarton Highway, North Vancouver, B.C., CANADA V7H 3B1
Tel. 604-984-3496 Fax 604-984-0246
www.valorfireplaces.com
to save them.
8:00 am
P1
low temp
Set temp
With low battery power
This green feature
4:00 pm
P2
high temp
40˚F
Set temp
Low Battery Indication
Caution
DO NOT USE a screwdriver or other metallic
object to remove batteries from holder. This
could cause a short-circuit.
Handset: The battery icon
battery needs to be replaced. Replace with one 9 V
alkaline battery.
Battery holder:
the valve motor turns indicate the batteries need to
be replaced in battery holder. Replace with four 1.5 V
alkaline batteries.
Handset / Receiver Match
The remote control handset and receiver are
programmed to function together. In case of a
replacement of the handset or the receiver, you will
need to reset the receiver to allow them to function
together. Contact your dealer for details.
10:00 pm
P2
low temp
74˚F Set temp
will show when the
Frequent 'beeps' for 3 seconds when
6:00 am
P1
high temp
40˚F
5