Télécharger Imprimer la page

Matco Tools MWL40SMD Instructions De Fonctionnement page 5

Lampe del 40 smd sans fil

Publicité

Les langues disponibles

Les langues disponibles

FAILURE TO OBSERVE THESE WARNINGS COULD RE SULT IN IN JU RY.
sAVe tHese instructions!
SAFETY INSTRUCTIONS FOR BATTERY
CHARGER AND BATTERY PACK
dAnger! reAd cArefully
120 Volts present at charging terminal. Absolutely do not
probe with conductive objects.
1. CAREFULLY READ AND UNDERSTAND THESE INSTRUCTIONS
This manual contains critical safety and operating instructions
for the light, battery charger, and battery.
2. Before using battery charger, read all instructions and
cautionary markings on (1) battery charger, (2) battery, and
(3) product using battery.
3. CAUTION - To reduce risk of injury, charge only MATCO
rechargeable batteries marked on the charger label. Other
types of batteries may burst causing personal injury and
damage.
4. Do not expose charger to rain or snow.
5. Use of an attachment not recommended or sold by Matco
or the battery charger manufacturer may result in a risk of
fire, electric shock, or injury to persons.
6. To reduce risk of damage to electric plug and cord, pull by
plug rather than cord when disconnecting charger.
7. Make sure cord is located so that it will not be stepped on,
tripped over, or otherwise subjected to damage or stress.
8. An extension cord should not be used unless absolutely
necessary. Use of improper extension cord could result in
a risk of fire and electric shock. If extension cord must be
used, make sure:
a. That pins on plug of extension cord are the same
number size, and shape as those of plug on charger;
b. That extension cord is properly wired and in good
electrical condition;
c. That wire size is at least as large as the one specified
in the table below.
table 1: recoMMended MiniMuM Awg siZe for
eXtension cords for bAttery cHArgers
Length of Cord (Feet)
AWG Size of Cord
9. Do not operate charger with damaged cord or plug -
replace them immediately.
10. Do not operate charger if it has received a sharp blow,
been dropped, or otherwise damaged in any way; take it
to a MATCO AUTHORIZED service facility.
11. Do not disassemble charger or battery cartridge; take it to
your MATCO AUTHORIZED distributor service facility. Incorrect
reassembly may result in a risk of electric shock or fire.
12. To reduce risk of electric shock, unplug charger from outlet
before attempting any maintenance or cleaning. Turning off
controls will not reduce this risk.
13. The battery charger is not intended for use by young children
or infirm persons without supervision.
14. Young children should be supervised to ensure that they do
not play with the battery charger.
MWL40SMD
MWL40SMD 40 SMD LED Cordless Light
25
50 75
100 150
18
18 16
14 12
WARNING
OPERATIONAL GUIDELINES
FOR BATTERY CHARGER AND
BATTERY PACK
1. Do not attempt to use a step-up transformer, an engine
generator or DC power receptacle.
2. Do not allow anything to cover or clog the charger vents.
3. Always cover the battery terminals with the box or cover
when the battery cartridge is not used.
4. Do not short the battery cartridge:
a. Do not touch the terminals with any conductive material.
b. Avoid storing battery cartridge in a container with other
metal objects such as nails, screws, coins, etc.
c. Do not expose battery cartridge to water or rain. A battery
short can cause a large current flow, overheating, possible
burns and even a breakdown.
5. Do not store the light and Battery Cartridge in locations
where the temperature may reach or exceed
50°C (122°F).
6. Do not incinerate the Battery Pack even if it is severely
damaged or is completely worn out. The battery cartridge
can explode in a fire.
7. Be careful not to drop, shake or strike battery as it will affect
the capacity and may void warranty.
8. Do not charge inside a box or container of any kind. The
charger and battery are ventilated devices and must NOT be
placed next to a heat source or in exposure to radiating heat.
9. Place charger on a solid and sturdy surface as there are
vents on the bottom side of the charger.
10. Always unplug the charger from the power supply when a
charging sequence is not taking place.
5
11/13/14

Publicité

loading