Tristar PD-8752 Mode D'emploi page 4

Instruction manual
• Joists, beams and rafters shall not be cut or
notched to install the appliance.
• Please do not install the appliance close to
curtains and other combustible materials.
This could cause a fire.
• Regulations concerning the discharge of air
have to be fulfilled.
• The appliance shall, under no
circumstances, be covered with insulating
material or similar material.
• The heater must not be located immediately
below a socket-outlet.
• The heater needs to be installed so that the
switches and other controls cannot be
touched by a person in the bath or shower.
• WARNING: The heater must not be used if
the ceramic panels are damaged.
• WARNING: This heater is not equipped with
a device to control the room temperature. Do
not use this heater in small rooms when they
are occupied by persons not capable of
leaving the room on their own, unless
constant supervision is provided.
PARTS DESCRIPTION
1. Heating position control knob.
2. Fan speed control.
4
3. Safety tip-over switch.
BEFORE THE FIRST USE
• Place the device on a flat stable surface and ensure a minimum
of 10 cm. free space around the device. This device is not
suitable for installation in a cabinet or for outside use.
• When the device is turned on for the first time, a slight odour will
occur. This is normal, ensure adequate ventilation. This fragrance
is only temporary and will disappear soon.
USE
• Plug the power plug into the wall socket.
• Use the heating position control knob to select the desired
heating mode.
• Turn on the appliance by turning the speed control knob
clockwise to the desired position.
CLEANING AND MAINTENANCE
• Always unplug the device and let it cool down completely before
cleaning
• Clean the outside with a damp cloth. Never use harsh and
abrasive cleaners, steel wool or a scouring pad as this will
damage the device. Do not immerse in water or other liquid.
• Clean de air inlet and outlet regularly with a vacuum cleaner to
remove dust.