Publicité
Les langues disponibles
Les langues disponibles
• Charge the battery provided with or identified for use with this product only in
accordance with the instructions and limitations specified in this manual.
• Observe proper polarity orientation between the batteries and battery
charger/compartment.
• Disassembly of your fixture will void the warranty.
• Fixture is suitable for wall mount only. NOT suitable for ground mount installation.
SAVE THESE INSTRUCTIONS
FOR BEST RESULTS
• Locate solar panel in an area that will receive the maximum amount of sunlight
during the daylight hours.
• Allow fixture to receive four full days of sunlight before turning fixture ON.
• Install your fixture 6-8 feet above ground (motion detector is less sensitive
above 8 feet).
• Locate fixture so motion moves across detection zone (Fig. 1).
• Locate fixture away from heat producing sources to prevent
false triggering. Also be very careful not to include objects
such as windows, white walls, barbecues, air conditioners,
flue vents, and water in the detection zone whenever
possible.
• Locate fixture away from moving objects such as trees and
street traffic.
• Do not aim the sensor at reflective surfaces such as smooth white walls,
swimming pools, etc.
• Keep solar panel clear of any objects that will block the sunlight. It will be
necessary to periodically clean the solar panel with soft wet cloth.
• During periods of several cloudy days, the battery will become discharged and
will need to be recharged with sunlight.
• After receiving full charge, fixture ON capacity is up to 3 hours.
Note: All PIR sensors in cold/dry environments are more sensitive than those in
hot/wet environments.
HOW TO REPLACE BATTERIES
Note: Use only the following type and size batteries: "AA" Ni-MH rechargeable
batteries. Make sure that replacement batteries are the same dimension as
current batteries.
1.
Unlock fixture from mounting plate by inserting the key (supplied) in the lock
on the side of the fixture. Rotate key to the OPEN position. Remove the
fixture from the wall by lifting up on the bottom of the fixture. Support the
fixture securely with both hands.
2.
Rotate the fixture so that you are looking at the back mounting surface of the
fixture. Move the switch to the OFF position.
3.
Make sure that the switch is in the OFF position before you proceed. Remove
the four (4) screws from the battery cover to expose the batteries.
Call for customer service and/or missing or damaged parts (800-334-6871)
3
Fig. 1
Publicité
