Epson ET-16500 Guide Rapide page 4

If you are using the automatic document feeder (ADF), check these areas:
If the paper feeds incorrectly in the ADF:
■
Make sure your originals are not creased or folded, and do not contain holes, staples,
tape, or other materials that could obstruct the feeder.
■
Check that the edge guide is set firmly against the original that you are copying, but it
is not too tight.
■
Fan your stack of originals and tap them gently on a flat surface to even the edges.
At the back of the printer, open the rear cover, remove the auto-duplexer, and check these
areas:
Network Problems
■
Try connecting to the wireless router or access point with your computer or another
device to confirm that it is working correctly.
■
Try restarting the router (turn it off and then on), then try to connect to it again.
■
Verify that the network settings are correct and check the signal strength. If it is poor,
try moving the product closer to your router or access point.
4
Network Problems
Open the duplexer