EN
USER MANUAL
Connect to water tap, use thread adaptor if necessary. Leave water faucet opened. If the
A
controller has no power, please put it under the sunlight for 30 minutes then start to set
up and use it.
B
Auto
1
0ff
2
Set time
3
Start time
4
Frequency
5
SET TIME
1
Press
for 5 seconds to reset. Then use the + and – buttons to set the clock to correct
time. When using the + and – buttons, hold them down to scroll faster. Press
time setting and move to
START TIME
2
Use the + and – buttons to set the time that you want to start watering. Press
the watering start time and go to
FREQUENCY
3
Use the + and – buttons to set how often your garden will be watered. You can water for
every 2 minutes up to 7 days. Press
RUN TIME
4
Use the + and – buttons to set the desired watering duration, from 1 minute up to maxi-
mum of 720 minutes. Please note that run time cannot be longer than frequency. Press
to finish the settings. This controller is ready for watering.
AUTO
5
AUTO mode, all your settings are displayed on the LCD screen alternately and
In
changed every 3 seconds.
MANUAL WATERING
6
to turn on the water and use the + and – buttons to select the watering duration
Press
time, from 1 minute to a maximum of 720 minutes. To stop manual watering, press
RAIN STOP PROGRAM SETTING
7
In the
AUTO mode, you can press + button to delay its automatic cycle for 12 hours to
maximum of 7 days. Press
OTHER NOTICES
8
No programming over 5 minutes will result in turning off the LCD panel (see diagram ) to
help saving energy. If you want to stop using this solar irrigation controller, please press
into the
OFF mode (see diagram
10
Run time
6
Indicator point
7
Watering flow / Stop
8
Battery indicator
9
Manual button
10
START TIME mode.
FREQUENCY TIME mode.
to save the settings and go to
to confirm the delay. Press – to cancel the delay setting.
), to save energy and protect the battery.
Select button
11
Increase button
12
Decrease button
13
to save the
to save
RUN TIME mode.
.