Start-Up; Adjusting The Material Volume - WAGNER Renuvo Manuel D'utilisation

Renuvo
•
Keep the red quick release fastener (fig. 2, a)
depressed and insert the application pad into the
holder. Release the quick release fastener and pull
lightly on the application pad to check that it is
engaged in place.

7. Start-up

If necessary cover floors and furniture
i
in the immediate vicinity to where
you are working to protect against
splashing.
•
If you are coating a smooth surface without grooves
outside, pull the groove brush out of the outdoor
application pad, turn it round and attach it. (Fig. 3)
•
Place the device on to a piece of masking material
with the container opening upwards. (Fig. 4)
Unscrew the lid on the container. Fill the container
to a maximum of 1.9 l. Screw the lid back on tight.

8. Adjusting the Material Volume

Material flow limiter (fig. 5):
•
Push the limiter up to reduce the material flow
(recommended for thin materials).
•
Push the limiter down to increase the material flow
(recommended for thick materials).
Trigger:
•
Press the trigger to have the material flow into
the application pad. (Fig. 6, a)
•
Release the trigger to interrupt the material flow.
(Fig. 6, b)

a




b
GB
a
13