Publicité
Les langues disponibles
Les langues disponibles
iCONNEX
CONNECTIONS
INPUT (PHONO):
The PHONO input accepts any standard mag-
netic cartridge, stand alone turntable or record
player.
Connect your record player to the PHONO input
making sure to connect the thin black GROUND
wire to the silver GROUND SCREW located on
the bottom of the iConnex, failure to connect the
ground wire will cause a humming to be present
in your recordings.
Once you have chosen which INPUT you are go-
ing to use, make sure that the INPUT SELECTOR
SWITCH is in the appropriate position: LINE if
you are using the LINE input or PHONO if you are
using the PHONO input.
OUTPUT:
The OUTPUT section allows you to use the iCon-
nex as an output for your computer and can be
used instead of your computers built in output.
You may then connect the OUTPUT of the iCon-
nex to any Mixer, Stereo Receiver, Amplifier or
any system with a LINE level or AUX input. Then
use the built in THUMB WHEEL volume control
located on the side of the iConnex to adjust the
volume of the iConnex output.
Once you have made all the proper connections
you may then setup your computer, although the
iConnex is a PLUG AND PLAY device there may
be some settings you need to go over depending
on your computers configuration.
For your computer settings and an Audacity RECORDING
SOFTWARE overview please continue to the next page.
(cont.)
IF YOUR TURNTABLE IS
MISSING A GROUND WIRE
YOU MUST REATTACH ONE
OR THE TURNTABLE OUT-
PUT WILL EMIT A HUM!
BOTTOM
WARNING!
ENGLISH
TOP
Make sure the
input select
switch is set to
the input you
are using.
Use the built in
THUMB WHEEL
to adjust the
output volume
Publicité
