Fenton FT12LED Manuel D'instructions page 3

UNPACKING INSTRUCTION
CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are
present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if
any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing
materials. In the event that the product must be returned to the factory, it is important that the product be returned in the original
factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
On the label on the backside of the product is indicated on this type of power supply must be connected. Check that the mains
voltage corresponds to this, all other voltages than specified, the light effect can be irreparably damaged. The product must also
be directly connected to the mains and may be used. No dimmer or adjustable power supply.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
OPERATIONS INSTRUCTIONS
Make sure the volume control is minimal. Plug one end of the AC cord provided into the AC input jack on rear side of the
portable sound system. Then plug the other end of AC cord into AC power outlet. Turn on the unit using the main power switch.
Rechargeable Battery
This unit can be powered internally using the built-in rechargeable battery. When AC power is connected, CHARGE LED
indicator will light red. The rechargeable battery is being charged. If FULL LED indicator light green, the battery is fully charged
and ready to power the unit alone.
Turn off the power switch and disconnect the AC power. Turn the unit back "ON" and the rechargeable battery will power the
unit alone.
Note: Turning off the unit power switch will allow the battery to be charged more quickly.
ATTENTION:
Before the device the first time is actuated, please charge the battery at least 12 hours and max. 72 hours!
Battery should be regularly charged. For optimal battery life the battery should be charged at least 1x per month.
Please note that if you do not load within 6 weeks, the battery becomes defective !!
MEDIAPLAYER
1. MP3/AUX/BT-MODE
Press key to switch between MP3 player, Aux input or
Bluetooth.
Press and hold key to switch voice off/on.
2. RECORD
Press key for recording on USB/SD port.
3. REPEAT
Press key for repeating of single track or all tracks.
4. PREVIOUS TRACK / VOL-
Press key to select the previous track for playing. The
volume will be reduced by pressing the key for longer than
3seconds
5. PLAY/PAUSE
Press key to switch between pause or playing.
6. NEXT TRACK / VOL-
Press key to select the next track for playing. The volume will
be increased by pressing the key for longer than 3 seconds.
7. SD PORT
Connect your SD/MMC card in this slot to play music with MP3 or WMA format.
8. USB PORT
Connect your USB devices to this slot to play music with MP3 or WMA format.
9. TF PORT
Connect your TF card in this slot to play music with MP3 or WMA format
10. LCD DISPLAY
Display show you some information as playback support, file name, elapsed time, total time, file number, total file
number, file and playback mode.
3