Home Comfort EF-14C Mode D'emploi page 30

Step1: Select the wall location where you want to hang your electric fireplace heater. Draw a horizontal line using a level and mark 4 drill holes for the
anchor screws. See Fig. A.
NOTE: The holes are for mounting of fireplace and it shall be level so that the fireplace can be mounted properly and leveled. Marking out the hole
positions on wall according to Fig. A）
Fig. A
Step 2: Drill 4 holes 8mm (5/16 in) in diameter and 40mm (1.6 in) deep on the marked locations. For holes that do not hit stud, use the supplied wall
anchor. Install the wall anchors into the holes and gently tap them into place with a hammer until the flange of the wall anchor is flush with the wall
surface. See Fig. B.
Fig. B
Step 3: Secure the mounting bracket to the wall anchors using the 4 anchor screws and 4 Plastic expansion tube as shown in Fig. C.
Fig. C
30