Accessory Contents; Different Welding Options - Blue Hawk FLUX-MIG 100 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

ACCESSORY CONTENTS

R
Part
Description
P
Q
Contact tips
R
Gas tube
S
Welding lens
T
Face shield
U
W
Gas Tube Safety Clip
Hammer
X
Hand Shank
Y
Hand Shank
Z
screw and nut
PREPARATION
Remove all accessories from top of welder.
Put accessories together so that they are available to use before you begin welding.
Wrench - Use wrench to tighten or loosen positive and negative terminal outputs. Please see
different welding options section for different configurations of welding terminals.
Contact tips - See step by step instructions for how to attached tips to gun nozzle. There are
three contact tips provided: 0.025 in., 0.030 in. and 0.035 in.
Gas tube - Tube that is used to connect an external gas cylinder to the back of the welder.
Please consult your local retailer to see which external gas cylinder is compatible with this
welder. Make sure to secure gas tube (if gas is used) with gas tube safety clip.
Face shield/Welding lens/Face shield handle - Place the welding lens
on inside of face shield and slide welding lens into place. Make sure that
the welding lens snaps into place where the plastic tabs on the inside hold
the welding lens in place properly. Look at the face shield and make sure
there are no gaps in which the lens would not provide the proper eye
protection. Attach the face shield handle by lining up the two slots and
pressing down and up so that the handle locks onto the face shield. DO
NOT USE FACE SHIELD WITHOUT HANDLE, AS YOU NEED TO HAVE
PROPER CONTROL OF FACE SHIELD DUING WELDING PROCESS.
W
.025
K
XD
Quantity
Wrench
Handle
Q
Y
1
2
1
1
1
1
1
1
1
1
7
Z
P
S
X
T
www.lowes.com
U
®

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Sgy-welder10425019

Table des Matières