Bushnell 201965 Mode D'emploi page 4

GETTING STARTED
OPERATIONAL SUMMARY
While looking through the G Force 1 300 ARC™, depress the power button once to activate the Vivid Display. Place the
aiming circle (located in the center of the field of view) upon a target at least 5 yards away, depress and hold the power
button down until the range reading is displayed near the bottom of the in-view display. Crosshairs surrounding the
aiming circle indicate that the laser is being transmitted. Once a range has been acquired, you can release the power
button. The crosshairs surrounding the aiming circle will disappear once the power button has been released (i.e. the
laser is no longer being transmitted).
Note: Once activated, the display will remain active and display the last distance measurement for 3 seconds. You can depress the power button again
at any time to distance to a new target. As with any laser device, it is not recommended to directly view the emissions for long periods of time with
magnified lenses. The maximum time the laser is transmitted (fired) is 7 seconds. To re-fire, press the button down again.
6
VIVID DISPLAY INDICATORS
Your G Force 1 300 ARC™ Vivid Display™ incorporates the following illuminated indicators:
Angle Range Compensation Modes
Rifle Mode ( 1 )
Bow Mode (2)
Battery Life Indicator (3)
Aiming Circle (4)
Active Laser (5)
Targeting Modes
BullsEye Mode (6)
Brush Mode (7)
Primary Numeric Display displays Line-of-sight Distance (8)
Holdover / Bullet-drop measure for Rifle Mode
MOA (9)
CM ( 1 0)
IN ( 11 )
ML (12)
SD = Variable Sight-In Distance ( 1 3)
Secondary Numeric Display ( 1 4)
(Toggles from Degree of Angle to Holdover / bullet drop for Rifle mode)
(Toggles from Degree of Angle to True Horizontal Distance for Bow Mode)
13
4
1
5
6
2
12
3
SD
Y M
7
CM
8 MOA
IN
10
9 11
14
7