Napa 791-2002 Manuel De Fonctionnement page 3

SETUP
1. Screw the post support in the round base.
2. Thread the large spin handle on the extension screw.
3. Secure the saddle on the top of the extension screw using the hex bolt provided.
4. Install the bearing assembly in the receiver on top of the support tube.
5. Insert the extension screw assembly through the bearing and into the support tube until the underside of the spin handle rests on
the bearing assembly.
OPERATING INSTRUCTIONS
This is the safety alert symbol used for the OPERATING INSTRUCTIONS section of this manual to alert you to potential
personal injury hazards. Obey all instructions to avoid possible injury or death.
1. Make sure the vehicle is properly supported, stable and at the required work height before positioning the stand(s) under the
vehicle component to be supported.
2. Consult the vehicle manufacturer for the proper handling of the component and use of under hoist stands.
3. Once the stand(s) has been positioned properly under the component, hold the stand's saddle in place with one hand while
turning the spin handle in a clockwise direction with the other hand. Remove the one hand from the stand's saddle when it comes
close to making contact with the component.
4. Continue turning the stand's spin handle in a clockwise direction until it applies pressure against the component. This pressure
should not exceed what is required to support the component. Excessive pressure might cause the vehicle or its
component to become unstable.
5. Before removing the stand from the component, make sure the component is securely fastened to the vehicle or properly
supported by another means. Removal of the stand can be accomplished by turning the spin handle in a counterclockwise
direction until the stand's saddle is clear of the component.
PREVENTATIVE MAINTENANCE
This is the safety alert symbol used for the PREVENTATIVE MAINTENANCE section of this manual to alert you to potential
personal injury hazards. Obey all instructions to avoid possible injury or death.
1. Always store the stand in a well protected area where it will not be exposed to inclement weather, corrosive vapors, abrasive
dust, or any other harmful elements. The stand must be cleaned of water, snow, sand or grit before using.
2. Use a general purpose grease to lubricate the extension screw.
3. Every stand owner is responsible for keeping the stand labels clean and readable. Use a mild soap solution to wash external
surfaces of the stand. If product labels are lost or not legible, contact an authorized NAPA repair center for replacements.
4. Inspect the stand before each use. Do not use the stand if any component is cracked, broken or bent. Do not use the stand if it
has loose or missing hardware or components, or is modified in any way. Take corrective action before using the stand again.
Premature wearing or damage to components caused by loose or missing hardware is not eligible for warranty consideration.
WARRANTY
Please contact your local NAPA Auto Parts Store for details on warranty.
791-2002
OPERATING MANUAL & PARTS LIST FOR 791-2002
3 rev. 11/03/15