Lindy 40969 Manuel Utilisateur page 6

User Manual English
Installing the support plate
Insert the support plate into the column
along the inside rails of the column.
Tighten all screws using a screwdriver
(not included).
Installing the display brackets
Insert the 4 washers into the rear of the
display plate along the rails of the plate
Slide the display brackets onto the display plate. Ensure the
holes in the washers are aligned with the holes in the display
brackets. Loosely fit the four bolts.
Attach the two plastic covers to either end of the display plate.
Secure these using screws and tighten using a screwdriver (not
included).
Adjust the display brackets to fit the VESA sizing of
the display. Tighten all fixings using the included Hex
Key.