Description Of The Product; List Of Parts; Description Of Control Panel; Limitations Of Use - PEDROLLO TISSEL-200 Mode D'emploi Original

DESCRIPTION OF THE PRODUCT

TISSEL-200 is a speed regulator with the following characteristics.
• Input is a single-phase alternating voltage.
• Supplies a three-phase alternating voltage.
• Keeps the pressure of the installation constant (curves with variable revolutions).
• Controls the hydraulic and electrical operating parameters, and protects the pump from faults.
• It can be fitted with an expansion card which enables it to work in parallel with other inverters in the pump units and to man-
age an input signal and an output signal.
• It adapts to function with any type of pressurisation plant including current ones.
• It is energy saving as it limits the start-up and operating electric current.
• Allows the selection of the supply and output voltage.

LIST OF PARTS

1. Inverter
2. Pump
3. Control Panel
4. Cable seal
5. Power card cover
6. Technical data plate

DESCRIPTION OF CONTROL PANEL

1. ON/OFF switch
2. LED – red when POWER on
3. LED – green when in operation STATUS
4. Display
5. SET key
6. Keys of the slider arrows

LIMITATIONS OF USE

• Maximum working pressure: 9 bar (130 p.s.i.).
• Permissible fluids: clean water and chemically non-aggressive liquids; if the liquids contain impurities install a filter upstream.
• Maximum ambient temperature: 40 °C, with the possibility of changing the air.
• Minimum ambient temperature: 0 °C
• Maximum temperature of the fluid: 50 °C
• Minimum temperature of the fluid: 0 °C
• Permitted variation in the supply voltage +/-10% compared to the plate data.
• TISSEL-200 is not suitable for pumping inflammable liquids or for operating in areas where there is a danger of explosion.
28 | ENGLISH
1
3
5
4
2
3
1
2
6
4
6
5