Tool Use And Care; Service - Maxus MX5222 Instructions D'utilisation

Important Safety Information (Continued)
d. Keep clear of nozzle. NEVER direct high pressure spray at a
person, animal, or yourself.
e. NEVER put hand or fingers over the spray tip while operating
the unit.
f. NEVER try to stop or deflect leaks with any body part.
Ensuring that the tool is used
only when the operator and all
other personnel in the work area are wearing ANSI Z87
eye protection equipment, and when required, other
appropriate protection equipment such as head, hearing
protection, gloves, rubber boots, protective clothing when operating
and performing maintenance. Serious eye or permanent hearing loss
could result.

TOOL USE AND CARE

Do not use pressure that exceeds the operating
pressure of any of the parts (hoses, fi ttings, etc.)
in the pressurized system. Ensure all equipment and accessories are
rated to withstand the maximum working pressure of the unit.
Explosion hazard:
a. Maintain the tool with care. A properly maintained tool
reduces the risk of problems and is easier to control.
b. Ensure safety devices are operating properly before each use.
DO NOT remove or modify any part of the gun or unit.
c. NEVER operate the machine without all components
properly connected to the machine (handle, gun/wand
assembly, nozzle, etc.).
d. Know how to stop this product and bleed pressure quickly.
Be thoroughly familiar with the controls.
e. ALWAYS engage the trigger safety latch in the safe position
when spraying is stopped even if only for a few moments.
f. NEVER permanently engage the trigger mechanism on the
gun.
g. ALWAYS follow detergent manufacturer's label
recommendations for proper use of detergents. Always
protect eyes, skin, and respiratory system from detergent
use.
h. NEVER disconnect the high pressure discharge hose from
the machine while the system is pressurized. To depressurize
machine, turn power and water supply off, then press the
gun trigger 2-3 times.
i. Do not remove fuel tank cap or fill fuel tank while engine
is hot or running (allow engine to cool two minutes before
refueling). Always fill the tank slowly.
j. Follow the maintenance instructions specified in the
manual.
Equipment damage:
k. ALWAYS turn water supply "ON" before turning pressure
washer "ON." Running pump dry causes serious damage.
l. Do not operate the pressure washer with the inlet water
screen removed. Keep screen clear of debris and sediment.
m. NEVER operate pressure washer with broken or missing
parts. Check equipment regularly and repair or replace worn
or damaged parts immediately.
n. Use only the nozzles supplied with this machine.
o. NEVER leave the wand unattended while the machine is
running.
p. ALWAYS hold gun and wand firmly when starting and
operating the machine.
q. NEVER allow the unit to run with the trigger released (off) for
more than one minute. Resulting heat buildup will damage
the pump.
r. NEVER store the pressure washer outdoors or where it could
freeze. Freezing temperatures can seriously damage the
pump.
s. NEVER tamper with the engine governor or attempt to alter
factory settings. Altering factory settings could damage the
unit and will void the warranty.

SERVICE

a. When servicing a tool, use only identical replacement
parts. Use only authorized parts.
SAVE THESE INSTRUCTIONS — DO NOT DISCARD
DANGER WARNING
NOTE: The ,
notifi cations and instructions in this manual cannot cover all possible
conditions and situations that may occur. It must be understood by the
operator that common sense and caution are factors which cannot be
built into this product, but must be supplied by the operator.
Model MX5222
CAUTION NOTICE
, , and
5