Dolphin STAR + Mode D'emploi page 2

8. TROUBLESHOOTING
If the suggest solutions do not solve the problem contact your dealer
Symptom Possible reason
1. Cable twisting • Obstruction in pool
or cable coils up
• Excess cable in the pool
• Filter bag/cartridge dirty
• In all abovementioned cases
2. The Pool Cleaner • Dirt stuck in moving parts
is moving in
• Clogged filter bag/cartridge
circles
• Power supply incorrectly
• Incorrect mounting of bottom lid
• Algae or pool water is out of Spec
3. The Pool Cleaner • Power supply incorrectly
does not cover
the entire pool
• The handle is not positioned
4. The Pool Cleaner • Filter bag/cartridge is full
does not climb
• Algae on walls
walls
• Water temperature too low
• Brushes worn
• Slippery ceramic wall tiles
• Debris caught around impeller
• The Pool Cleaner is too light -
• Unsuitable pH level
5. Motors • Impeller blocked
not working
• Drive system blocked
• Electrical problem - motor unit,
6. The Pool Cleaner • Air caught in filter bag/cartridge
will not sink
• Special combined climbing
7. Power supply • Not plugged properly or
or power supply
switch light is
not working
Robotic Pool Cleaner Classic 4-UNI
positioned
positioned
in accordance to the pool
conditions
trapped air
cable or power supply
brushes are dry
non - functioning socket
User Instructions
|
Corrective action
• Remove obstruction in pool.
• Remove excess cable out of the pool.
• Clean filter bag/cartridge.
• Straighten cable and lay in sun periodically.
• Remove dirt from moving parts.
• Clean filter bag/cartridge.
• Place power supply in a position so that the
Pool Cleaner can reach all walls.
• Lock bottom lid in the right position.
• Correct pool and water conditions.
• P lace power supply in a position so that
the Pool Cleaner can reach all walls.
• Y ou may enhance the pool coverage by adjusting
the handle float. For optimal pool coverage the
Pool Cleaner should turn on the floor at 90° angle
(the Pool Cleaner rotates twice before completing
the 90° turn).
1. If the Pool Cleaner does not complete a 90° turn,
shift the float opposite to the cable's entry–side
towards the handle center.
2. If the Pool Cleaner turns in an angle wider than 90°,
shift the float on the cable's entry-side towards
the handle center.
• Empty and wash filter bag/cartridge.
• Brush walls.
• Ideal water temperature between 6°-34°C / 43°-93°F.
• Replace brushes - contact your dealer.
• Consult with your dealer about special brushes.
• Remove impeller tube. Clean impeller.
• Turn the Pool Cleaner upside down under water
to remove trapped air.
• Check pH level between 7 and 7.8.
• Remove impeller tube and clean impeller.
• Clean tracks and wheels.
• Consult with your dealer and Service Center.
• Turn the Pool Cleaner upside-down under
water to remove trapped air. Wash the filter bag/
cartridge.
• Open two inlet flaps in the bottom lid to remove
dirt and/or trapped air.
• Soak brushes in water.
• Check power to the socket and reconnect
the Pool Cleaner.
11