Samsung NZ36K6430R Serie Manuel D'utilisation page 18

Operations
Triple surface unit control knob (center)
The triple surface unit features 3 elements. You can select 1, 2 or 3 elements
depending on the size of the pot or pan you are using.
[ ] indicates the single power zone, [ ] indicates dual power, and [ ] indicates
triple power.
2
A C
1
B
NOTE
If you remove the knobs for cleaning, make sure to re-attach them in the correct
orientation. (Refer to the illustrations on the previous page.)
CAUTION
• Please note: The operation of a control knob may not synchronize with the
actual operation of the radiant element if there is a problem with the cooktop.
• The area on the knob between the high and off settings is not appropriate for
cooking.
18 English
NZ36K6430R_DG68-00822A-00_EN+MES+CFR.indb 18
1. Push the knob in.
2. Turn in either direction to the setting
you want.
• To use the single surface unit, turn
the control knob to the [ ] single
element setting.
• To use the dual surface unit, turn the
control knob to the [ ] dual element
setting.
• To use the triple surface unit, turn
the control knob to the [ ] triple
element setting.
Recommended settings
The power levels in the table below are guidelines. The power settings required
for various cooking methods depend on a number of variables, including the
quality of the cookware being used and the type and amount of food being
cooked.
SETTING
• Starting most foods
• Bringing water to a boil
HIGH
• Quickly searing meat
• Pan boiling
• Continuing a rapid boil
MEDIUM HIGH
• Deep fat frying, pan frying, stir frying
• Maintaining a slow boil
MEDIUM • Thickening sauces and gravies
• Steaming vegetables
MEDIUM LOW • Keeping foods cooking, poaching, stewing
• Melting chocolate or butter
LOW • Keeping foods warm
• Simmering
NOTE
• The power settings indicated in the table above are provided only as
guidelines for your reference.
• You will need to adjust the power settings according to the cookware you are
using and the food you are cooking.
TYPE OF COOKING
7/14/2016 7:23:31 PM