Laica BM1006 Instructions Et Garantie page 19

English
EN
Ensure that no liquids enter the appliance.
• This appliance is not waterproof.
• Place the device in the supplied case and, to store it, observe the environmental conditions
stated here below.
SPECIAL CASES
If the following circumstances occur:
1) After pressing the "O/I" key the reading does not start.
• Check the batteries and replace them if needed.
• Clean the contacts of the batteries with a dry cloth.
2) Nothing appears on the display when the "M" key is pressed.
• The batteries are flat.
3) The batteries do not last long.
• use alkaline batteries to increase working autonomy. If normal zinc-carbon batteries are
used they will need changing more often.
4) You cannot complete a reading.
• check the batteries and change them if needed.
5) The blood pressure levels are different with each reading - the readings are very low or very
high.
• the measuring position is not correct - Read the paragraph "Correct measuring position"
again.
• the blood pressure readings vary constantly depending on the time of day and the state
of nerves of the person. Read the paragraphs "Warnings" and "Important" again.
6) The heart beat readings are too high or too low:
• The person moved while the reading was being taken.
• The reading was taken after physical exertion.
Read the paraghaphs "CORRECT MEASURING METHOD", "WARNINGS" and
"IMPORTANT" again.
7) On the display, appears the symbol
• It has been detected the presence of an irregular pulse (arrhythmias). Repeat the
measurement. If the symbol
establish the most suitable treatment to be followed.
WRIST BLOOD PRESSURE MONITOR
.
appears again, refer to a physician to
38
Instructions and guarantee
COMPONENTS
1) LCD DISPLAY
2) "O/I" KEY
3) M KEY
4) ARMBAND
5) BATTERY COMPARTMENT
6) BATTERIES
7) CASE
TECHNICAL FEATURES
• Pressure indication range: between 0 and 300 mmHg (arm cuff pressure)
between 30 and 180 pulsations/min. (pulse frequency)
• Precision: ±3 mmHg (arm cuff pressure)
± 5% of the read value (pulse frequency)
• Inflating and deflating: automatic
• Power supply: 2 alkaline batteries type AAA (LR03)
• Memories: 60 Memories per area (2 areas)
• Working conditions: between +5°C and + 40°C; 85% relative humidity or lower
• Storage conditions: between -10°C and + 50°C; 95% relative humidity or lower
• Wrist circumference: between 135 and 215 mm approx.
• Dimensions: 77x62x33 mm
• Weight: about 120 g (without alkaline batteries)
Attention. Carefully check the instructions for use.
Type BF appliance
IP22: Degree of protection of electrical equipment covers, where the first figure indicates the
degree of protection against penetration by solid foreign bodies (from 0 to 6) and the
second figure the degree of protection against penetration by liquids (from 0 to 8).
ELECTROMAGNETIC COMPATIBILITY
This device complies with current regulations relating to electromagnetic compatibility (EMC)
English
39
EN