Safety Instructions - CORE powertools CX25 C3H Manuel D'utilisation

Safety instructions

•
Only switch gears when the motor is in a complete standstill
•
Plug in the machine only when it is switched off
•
Prevent water with electricity through leaking, or dripping from the hose
•
A water collecting device must be used when drilling overhead.
•
Remove water safely using a water pump
•
Always use the machine under supervision. Keep hands away from rotating parts
•
Ensure you are always standing firmly during drilling.
•
Wear prescribed and suitably protective clothing
•
Due to the creation of dust particles, the use of a dust mask is recommended.
•
Double-check that the diamond drill is correctly assembled and parallel with the drill rig
•
Before use, check that all screws of the drill motor and drill rig are firmly in place. Because of vibrations caused during
drilling, screws can work loose and cause damage or injury
•
After use, do not touch metal parts of the drill machine and the diamond drill; this could be hot and cause burns.
•
Ensure that the drill machine does not start rotating by accident; always disengage the switch when disconnecting from the
power source, or if there is an interruption to the power supply
PRCD switch
The CX25 electrical cable is equipped with a PRCD switch which protects the operator against electrocution. As soon as the
drilling machine is plugged in, the PRCD should be started up by pressing on the (green) –RESET button. If the PRCD is switched
off, the –RESET button must be pressed again.
Note:
•
The PRCD and the electrical cable should never come in contact with water
•
Check the PRCD by pressing the –TEST button before use.
•
Never use the diamond drilling machine without a properly functioning PRCD
•
Never replace the standard plug with another type of plug
CX25 7
ENG
12/06