Télécharger Imprimer la page

Aflitheorem Theorem Prescriptions De Montage Et Mode D'emploi page 16

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 18
GB
OPERATION
Luce
D
C
E
B
A
F
From off position the stand-by control mode can be activated by pressing any button. The symbol will then light up
softly giving the user the possibility to see and choose the function.
By pressing one more time any button will activate the corrisponding function and the symbol will then light
upcompletely. To ensure a low level of energy consumption,this control has a special device which lets the
symbolsremain lighted up half way, in a stand mode, for about 1minute. The symbols will switch off afterwards.
A. ON/OFF button- atmosphere light: by pressing this button 4 lights situated at the back of the hood and on the sides
will switch on giving a decorative effect with a soft light.;
B. ON/OFF button- hood's light : by pressing this button 2 lights will switch on lighting the hob;
C. ON/OFF button- 4 speed motor: by pressing this button the hood will start to operate at the same speed as before
being switched off. By using D and E it is possible o change the extracting speed (capacity); GB INSTRUCTION ON
MOUNTING AND USE
D.Decreasing extracting speed (capacity) button: by pressing this button the extracting speed (capacity) will decrease;
E.Increasing extracting speed (capacity) button: by pressing this button the extracting speed (capacity) will increase;
F. ON/OF TIMER: by pressing this button the selected extracting speed (capacity) will last for 5 minutes; elected
extracting speed (capacity) indicator and filter saturation;
Grease filters saturation : after every 40 hours of use of the hood , the speed indicator will flash slowly indicating that
the metal filters need to be washed.
Charcoal filters saturation : after every 120 hours of use of the hood , the speed indicator will flash fast indicating that
the charcoal filters need to be replaced.
Note: by pressing at the same time the buttons D and E will eset the filters saturation indicator. Attention! This
functionshould only be used after performing the maintenance of the filters.
16

Publicité

loading