Important Safeguards - Maxx Ice MIM452 Manuel D'utilisation, D'installation Et D'entretien

IMPORTANT SAFEGUARDS

Before the ice maker is used, it must be properly positioned and installed as described
in this manual, so read the manual carefully We strongly recommend that you have
a professional install your new machine The warranty may be affected or voided
by an incorrect installation. To reduce the risk of fire, electrical shock or injury when
using the ice maker, follow basic precautions, including the following:
DANGER
• It is recommended that a separate circuit, serving only your ice maker, be provided Use
receptacles that cannot be turned off by a switch or pull chain
WARNING
• Do not connect or disconnect the electric plug when your hands are wet
• Never unplug the ice maker by pulling on the power cord. Always grip the plug firmly and pull
CAUTION
straight out from the outlet
• Never clean ice maker parts with flammable fluids. Do not store or use gasoline or other
flammable vapors and liquids in the vicinity of this or any other appliance. The fumes can create
a fire hazard or explosion.
• Before proceeding with cleaning and maintenance operations, make sure the power line of the
unit is disconnected and the water line is shut off (EXCEPTION: When cleaning the machine's ice
making and water systems)
• Before operating, put all the enclosure panels back into their original places
• Do not touch the evaporator with your hand when the machine is operating
• Unplug the ice maker or disconnect power before cleaning or servicing Failure to do so can
result in electrical shock or death
• Do not attempt to repair or replace any part of your ice maker unless it is specifically recommended
DANGER
in this manual. A qualified technician should do all other servicing.
WARNING
• Use two or more people to move and install ice maker Failure to do so can result in back or
CAUTION
other injury
• To ensure proper ventilation for your ice maker, the front of the unit must be completely
unobstructed Choose a well-ventilated area with temperatures above 50ºF (10ºC) and below
100ºF (38ºC) This unit MUST be installed in an area protected from the elements, such as wind,
rain, water spray or drips
• The ice maker should not be located next to ovens, grills or other sources of high heat
• The ice maker must be installed with all electrical and water connections in accordance with
state and local codes A standard electrical supply against the nameplate rating, properly
grounded in accordance with the National Electrical Code and local codes and ordinances is
required
• The fuse (or circuit breaker) size should be 20 amperes for the ice makers
• It is important for the ice maker to be well leveled for proper operation You may need to make
several adjustments to level it
• All installations must be in accordance with local plumbing code requirements
• Make certain that the hoses are not pinched or kinked or damaged during installation
• Check for leaks after connection
• Although the unit has been tested at the factory, due to long-term transit and storage, the first
batch of cubes must be discarded
• Remove the packing materials and clean the ice maker before using
• Turn on the water supply tap before switching on the ice maker Never turn off the water supply
tap when the ice maker is working
• Except to take ice from the storage bin, keep the bin door closed in order to reduce ice melting
and to promote proper ice formation
• If the ice maker will not be used for a long time, before the next use it must be thoroughly
cleaned Follow carefully any instructions provided for cleaning or use of sanitizing solution Do
not leave any solution inside the ice maker after cleaning
• DO NOT touch the condenser fins. The condenser fins are sharp and can be easily damaged.
3
DANGER
WARNING
CAUTION