Vonyx VSA120S Manuel D'instructions page 3

UNPACKING INSTRUCTION
CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts are
present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if
any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and all packing
materials. In the event that the product must be returned to the factory, it is important that the product be returned in the original
factory box and packing.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
On the label on the backside of the product is indicated on this type of power supply must be connected. Check that the mains
voltage corresponds to this, all other voltages than specified, the light effect can be irreparably damaged. The product must also
be directly connected to the mains and may be used. No dimmer or adjustable power supply.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
REAR PANEL
1. MP3 VOLUME LEVEL
Controls the MP3 input volume
2. MIC VOLUME LEVEL
Controls the microphone input volume
3. ECHO CONTROL
Controls the echo-effect
4. MIC 1 IN
This connector can take a 6.3mm Jack
balanced cabled microphone
5. MIC 2 IN
This connector can take an XLR balanced
cabled microphone
6. LINE VOLUME LEVEL
Controls the line input volume
7. LINE IN LEFT
XLR and RCA connectors for left line signal
input
8. LINE IN RIGHT
XLR and RCA connectors for right line signal
input
9. GUITAR VOLUME LEVEL
Controls the guitar volume
10. GUITAR IN
6.3mm jack input for connecting a guitar
11. MASTER VOLUME
This knob controls the master volume
12. BASS CONTROL
Adjust the low frequencies of the
corresponding channel
13. TREBLE CONTROL
Adjust the high frequencies of the
corresponding channel
14. LED INDICATORS (VU-METER)
The current system operation is indicated
on the 5 digit LED bar graph. The LED's
monitor the current output level within a
range of -13 dB and +3 dB
15. POWER LIGHT
Power ON/OFF indicator
16. AUX IN
Auxiliary 3.5mm input connector
17. MIX OUT
XLR connector for mix signal output
18. SPEAKER OUT 4 OHM
Passive speaker output connector, minimum load 4 Ohm! Only connect the supplied passive speaker to this connector.
19. POWER SWITCH
Turn the device ON or OFF
20. AC IN AND FUSE HOLDER
Socket for plugging in the supplied power cord (top). For instructions on how to change the fuse (bottom), see "REPLACING
THE FUSE"
3