Coleman Powermate 010-0012CT Manuel D'instructions page 4

TYPICAL TYPICAL
Key Description Key Description
A Air hose D In-line Oiler
B In-line Filter E Air Hose
C Tee Fitting F Whip Hose
OPERATING INSTRUCTIONS
OPERA
Spray Gun Setup
This spray gun is designed for use as a "bleeder
type", which means that air will continuously pass
through the gun without pulling the trigger. Paint or the
material being sprayed is added to the air stream by
pulling the trigger.
Depending on which of the supplied nozzles is
installed, this spray gun will provide External
Mix/Pressure Feed or Internal Mix/Pressure Feed.
For use as External Mix Pressure Feed:
1. Install the external mix nozzle (G) onto the
end of the spray gun.
NOTE: This set up is used when spraying
medium bodied, fast-drying materials
such as lacquers and fast-drying enamels.
For use as Internal Mix Pressure Feed:
1. Replace the external mix nozzle (G) with
the internal mix nozzle (H).
NOTE: This set up is used when spraying
relatively thick, slow-drying materials such as latex or oil based paints.
Spraying Instructions
1. As a standard practice, drain water from the air compressor tank and air lines
prior to use each day (reference your compressor operators manual for detailed
instructions). NOTE: Failure to install appropriate water/oil removal
equipment may result in damage to the spray gun or workpiece (see
Figure 1).
2. Install a 1/4" NPT female connector (not included) into the air inlet port on
the tool (see Figure 2). Note: Use Teflon® Tape on all threaded
connections.
3. Mix material according to the manufacutrer's instructions, adding thinner if
needed. Mixture should be smooth and easily pourable. Lumps or foreign
objects should be removed by straining through a suitable paint filter or
cheesecloth.
4. Fill the cup no more than 3/4 full. Firmly attach the cup to prevent air
leakage. Avoid damage to the sealing surface of the cup and the gasket.
Damage to these parts will cause air leaks and prevent the gun from
spraying properly. If paint leaks around the needle pin packing gland,
tighten the packing gland nut just enough to stop the leak but not enough
to interfere with movement of the needle pin. Apply light machine oil to
keep the packing soft and help avoid leaks.
5. Start the compressor and set the regulator to 25-50 PSI. NOTE: Be sure
there is sufficient hose connected between the gun and air supply to
comfortably reach the work surface.
INSTALLA INST ALLATION TION
Key Description Key
G Quick Coupler J Female Connector
H Male Connector K Spray Gun
I Air Tool
TING INSTRUCTIONS
Figure 2
4 - ENG
Figure 1
Description
Figure 3
Figure 4