Battery Instructions; Maintenance Instructions - Tork Matic 461102 Instructions

Table des Matières

Publicité

WARNING – RISK OF INJURY TO PERSONS
When using electric appliances, basic precautions should always be followed, including the following:
a)
Read all the instructions before using the appliance
b)
To reduce the risk of injury, close supervision is necessary when an appliance is used near children
c)
Do not contact moving parts
d)
Use only attachments or accessories recommended or sold by the manufacturer
e)
Do not use outdoors
OPERATIONAL ENVIRONMENT AND STORAGE:
This dispenser is not suitable for installation outdoors or in wet environments. It is not water-resistant.
Under no circumstances should the dispenser be hosed-down or contacted by a water jet. To ensure
proper function, the dispenser must be installed in an environment with minimum and maximum
ambient temperatures between 41 and 86°F (5 – 30°C). The dispenser should acclimate at these
temperatures for 24 hours prior to installation.

BATTERY INSTRUCTIONS:

Dispenser shall be powered with three (3) D type alkaline batteries. Do not use re-chargeable bat-
teries. Do not attempt to recharge batteries. For optimal performance, batteries should be stored at
temperatures between 41 and 86°F (5 – 30°C). Do not mix batteries from different manufacturers. Do
not mix batteries with different date codes. Do not mix new and used batteries. Three (3) batteries
are to be inserted in the door of the clear battery compartment with positive terminal facing up. When
batteries have been exhausted, they must be removed from the dispenser and safely disposed. If
the dispenser is unused or unopened for a long period of time, the batteries should be removed. The
supply terminals are not to be short-circuited. For battery installation, see Figure 2 on page 17 of the
operating instructions.

MAINTENANCE INSTRUCTIONS:

This dispenser has been made with a high-quality, fingerprint-resistant stainless steel material. Fail-
ure to follow cleaning instructions may result in damage to the surface. Exterior of dispenser should
be dusted daily with a soft, lint-free cloth. Do not use abrasive materials or paper towels as they may
scratch the surface. Always wipe or polish in the grain direction of the stainless steel. Always use a
clean cloth. Wipe surface as needed with a clean, damp cloth, or a solution of mild soap and water.
Promptly remove any soap or cleaning chemical from the surface with a damp cloth, and wipe dry.
Avoid cleaning products that contain bleach, hydrochloric acid or chlorides. These are often found in
toilet or tile cleaners. Do not use abrasive polishes, powders or steel wool. These may damage the
material.
The inside of the dispenser should be cleaned at least once per month, or when paper dust is visible.
Remove the paper roll. Clean dust inside the dispenser with a vacuum or compressed air. Always
wear eye protection when using compressed air. After removing paper dust, wipe the inside of hood,
roll arms, and other interior surfaces with a dry microfiber or slightly damp cloth. Do not spray liquid
or cleaners into the dispenser. Under no circumstances should the dispenser be cleaned with a water
jet. Damaged or malfunctioning product should be disposed of immediately to avoid potential injury.
INSTALLATION ALERT:
Installation of this recessed conversion dispenser (the "Product") requires substantial modifications to
the existing recessed, folded towel and waste dispenser. These modifications may not be reversible
after installation has begun. Do not install the Product until you have read this entire document.
This document sets forth the term and conditions for the use and installation of the Product. Com-
mencing installation of this Product indicates that the Buyer has read and understands this agreement
and accepts its terms and conditions.
1
ORIGINAL ENGLISH INSTRUCTIONS
IMPORTANT SAFETY INSTRUCTIONS
MODEL: 461102

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Matic 46110

Table des Matières