Philips Bodygroom 5000 Serie Mode D'emploi page 3

4
After cleaning, snap the cover back into
the trimming attachment ('click') (Fig. 15).
Shaving attachment
1
Pull the shaving foil unit out of the shaving
attachment (Fig. 16).
Note: The shaving foil unit is very delicate. Handle it carefully.
Replace the shaving foil unit if it is damaged.
2
Rinse the shaving foil unit with lukewarm water.
Make sure that you also remove any hairs that have
collected under the trimmers.
Do not clean the shaving foil unit with the cleaning
brush, as this may cause damage.
3
Remove hairs from the inside of the shaving
attachment with the cleaning brush and/or with
lukewarm water (Fig. 17).
4
After cleaning, snap the shaving foil unit back into
the shaving attachment ('click') (Fig. 18).
Storage
The charger has a special storage unit in which you can
store the trimming or shaving attachment, the cleaning
brush and the two combs.
1
Place the cleaning brush in the brush
holder (Fig. 19).
2
Place the trimming or shaving attachment on top of
the attachment holder (Fig. 20).
3
Slide the two trimming combs sideways into the
guiding grooves of the attachment holder. The tips
of the combs must point forwards (Fig. 21).
4
Slide the storage unit onto the back of the
charger (Fig. 22).
5
To remove the storage unit, pull it off the back of
the charger (Fig. 23).
Replacement
If you use the shaving attachment very frequently, replace
the shaving foil unit (type number TT2000) every year.
Replace a damaged shaving foil unit immediately.
1
Pull the shaving foil unit out of the shaving
attachment (Fig. 16).
2
Snap the new shaving foil unit into the shaving
attachment ('click') (Fig. 18).
Environment
- Do not throw away the appliance with the normal
household waste at the end of its life, but hand it in
at an official collection point for recycling. By doing
this, you help to preserve the environment (Fig. 24).
- The built-in rechargeable battery contains substances
that may pollute the environment. Always remove
the battery before you discard and hand in the
appliance at an official collection point. Dispose of
the battery at an official collection point for batteries.
If you have trouble removing the battery, you can
also take the appliance to a Philips service centre. The
staff of this centre will remove the battery for you
and will dispose of it in an environmentally safe way.
Removing the rechargeable battery
Only remove the rechargeable battery if it is completely
empty.
1
Take the appliance out of the charger and let
the motor run until the rechargeable battery is
completely empty.
2
Remove any comb and/or attachment from the
handle.
3
Remove the back panel with a screwdriver (Fig. 25).
4
Remove both side panels from the handle with a
screwdriver (Fig. 26).
5
Remove the clamps on the left and right side of the
handle with a screwdriver (Fig. 27).
6
Separate the two handle parts (Fig. 28).
7
Cut the two wires to separate the batteries from
the printed circuit board (Fig. 29).
8
Remove the batteries with a screwdriver (Fig. 30).
4203.000.5989.1
Do not connect the appliance to the mains again after
you have removed the rechargeable battery.
Guarantee & service
If you need information or if you have a problem, please
visit the Philips website at www.philips.com or contact
the Philips Customer Care Centre in your country
(you find its phone number in the worldwide guarantee
leaflet). If there is no Customer Care Centre in your
country, go to your local Philips dealer or contact the
Service Department of Philips Domestic Appliances and
Personal Care BV.
Guarantee restrictions
The shaving attachment, the trimming attachment and
the rechargeable batteries are not covered by the terms
of the international guarantee because they are subject
to wear.
3/9