Publicité
Les langues disponibles
Les langues disponibles
4 LEVEL THE WASHER OR DRYER
Stand the washer or dryer upright. Move it
A
close to its final location.
Make sure that the washer or dryer is level by
B
placing a level on top. Check side to side and
front to back.
Use an open
C
ended wrench to
adjust the legs in
and out. Tighten
the lock nut
against the
bottom of the
pedestal.
NOTE: To minimize vibration, the locking nuts must
be tight.
5 REINSTALL THE DRAWER
Check to be sure the slides are closed.
A
Slide the drawer into the opening. Align the
B
drawer supports to the slides on each side.
Reinstall the original screws into each drawer
C
slide. Tighten both screws.
Open the drawer fully. Slide drawer divider
D
into slots in the center of the drawer. The
drawer should slide smoothly when you push
it closed.
Installation Instructions
3
6 REMOVE SHIPPING SCREWS
Remove the 4 shipping screws on the back side of the
washer.
7 FINALIZE THE INSTALLATION
Refer to the washer or dryer Installation Instructions
to complete the installation.
Publicité
