Alfa Romeo AR0 Mode D'emploi page 12

MODEL REFERENCE PICTURE
AR0
AR0
* ADJUSTMENT
Inside the mechanism there is the block
illustrated in the picture.
If the handlebar stem is not stable after
closing, adjust screws 1 and 2 of the block
by screwing or unscrewing just enough to
increase the stability of the stem.
1 - Screw 1: use a 2.5 mm Allen wrench to
unscrew the screw.
2 - Screw 2: use a 3 mm Allen wrench to tighten
the block screw in the correct position.
3 - Once screw 2 has been adjusted, tighten
screw 1 again.
Outside the mechanism there is a hex socket
screw (3). If the handlebar stem is not very
stable after closing, adjust the screw in the
mechanism, by tightening or loosening it as
required to increase the stability of the stem.
11