Cleaning And Maintenance - MaxxHome FT125 Mode D'emploi

ASSEMBLING
Step 1 : Make sure four hole of front and back base in straight alignment, Put hole of back base
insert to cylinder of front base.
Step 2 : Take out the power cord from the central of base
Step 3 : Assembled base of central have four pieces of screw hole which fix into the screw holes
of body ,use 4 pieces of tapping screw, fix closely the body and base. Finally take the
power cord into the line hole.
Step 4 : Put the fan flatly.
CAUTION
1. Use as per the rating voltage.
2. Do not repair or remake the appliance by yourself, it should be repaired by the repairmen.
3. Do not operate the appliance with wet hands, in order to avoid damage.
4. If the supply cord is damaged, it must be replaced by a same cord from the manufacturer or
its service agents.
5. When the appliance is not in use, switch it off and unplug it.
6. Do not insert things to air outlets and inlets, in order to avoid damage.
7. Do not use the appliance near explosive and combustible gas.
8. Use the appliance only on a flat surface.
9. Do not use outdoors.
10. Do no turnover the appliance. Unplug the power supply If it is toppled over and there have
some water in the body. Dry the body before use.
11. Clean the appearance with a lightly damp cloth.It can clean with neutral detergents.
Do not rinse with water.
12. Do not make air outlets and inlets near the wall or curtain.
13. Do not knock or shake the body when use, otherwise it may cause stop.
14. The appliance must not located immediately below a socket outlet.
The rating current of socket should exceed 10A.
15. Do not use the appliance in the immediate surrounding of a bath,a show or a swimming
pool.
16. This appliance is not intended for use by persons including children with reduced physical,
sensory or mental capabilities or lack of experience and knowledge unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety.
17. Children should be supervised to ensure that they do not play with the appliance.

CLEANING AND MAINTENANCE

Clean with neutral detergent and soft cloth.
Attention: unplug the power plug when clean the appliance, since there have high pressure in the
body. Do not leave any water on the control panel.
ACCESSORY
Screws for assemble the base. Remote control.