Special Safety Instructions; Technical Data; Equipment Function; Overview (A) - Rothenberger ROCUT UKS 160/355 Instructions D'utilisation

1.3

Special Safety instructions

Please wear hearing protection. Exposure to noise can lead to loss of hearing.
Power sockets in outside areas must be fitted with residual current circuit-breakers. This is an
installation regulation requirement for your electric system. Please be sure to observe this when
using the equipment.
Please remove the plug from the electric socket before all work on the equipment.
Be sure the equipment is switched off before connecting it to the electric socket.
Always keep the connecting cable away from the sphere of action of the equipment. Always
guide the cable away from the equipment to the rear.
The machine is only permitted to be used by trained and authorised users!
2

Technical data

Voltage ......................................................... 230 V AC, 50/60 Hz
Nominal power consumption ........................ 1750 W
Idle rotary speed ............................................ 7600 1/min
Weight .......................................................... ca. 12,9 kg
Typical acceleration in hand-arm area ............ < 2,5 m/s2
Degree of protection ..................................... IP20
Protection class ............................................. II
Operating mode ............................................ S3
Sound pressure level (L
Sound power level (L
Circular saw blade, external Ø ...................... 180 mm
Drill hole Ø ........................... 30 mm
The noise level can exceed 85 dB (A) when working. Wear hearing protection! Measured
values determined in accordance with EN 60 745-1.
3

Equipment function

3.1 Overview
1
Hand-wheel
2
Clamping arms
3
Latching bolt
4 Feed lever
3.2

Electric supply

Only connect to one-phase alternating current and to the mains voltage indicated on the power
rating plate. Connection is also possible to sockets without earthing contact as this is a protection
class II assembly.
3.3

Start of operation

The ROCUT UKS 160/355 must be used only in a dry environment! During outdoor
operation, a ground fault circuit must be used!
Fix and secure the work piece/tube! The tube must be firmly anchored to prevent the
cutting end from moving, bending or falling down.
 Using the hand wheel (1), open the clamping arms (2) far enough so that the saw can be slid
from above or from the front onto the tube to be worked.
Make sure that the saw that is set on the tube sits on the tube's highest point or apex and
that the drive motor always points toward the end of the tube to be sawn off.
) ............................. 89 dB(A) ¦ K
pA
) ............................... 102 dB(A) ¦ K
wA
5
Guide handle
6
Carrying handle
7
Motor switch
ENGLISH
3 dB (A)
pA
3 dB (A)
wA
A
11