Riester ri-fox N Manuel De L'opérateur page 11

Possible Problems and resolutions
Problems
SpO or PR
1.Finger is not plugged correctly
2
can not be
2.Patient's Oxyhemoglobin value is
shown normally
1.Finger might not be plugged
SpO or PR is
2
shown unstably
2.Finger is trembling or patient's
1.Power of batteries might be
The Oximeter
can not be
2.Batteries might be installed
powered on
3.The Oximeter might be damaged.
1.The product is automatically
Indication
lamps are
suddenly off
2. Lower power
"Error3"or
1.Low power
"Error4" is
2.Mechanical malfunction for
displayed on
screen.
3. Amp circuit malfunction.
Possible reason
too low to be measured.
deeply enough.
body is in movement status.
inadequate or not be there at all.
incorrectly.
powered off when no signal is
detected longer than 8 seconds
receive-emission tube
1. Retry by plugging the finger.
2. Try some more times, If you
can make sure about no problem
existing in the product. Please go
to a hospital for exact diagnosis.
1.Retry by plugging the finger.
2.Try not to move.
1.Please replace batteries
2.Please reinstall the batteries
3.Please contact with local customer
service centre.
1.Normal
2.Replace the batteries
1.Change batteries.
2.Please contact the local customer
service center.
3.Please contact the local customer
service center.
- 10 -
Solution