PNI Turbo Heat 2900W Manuel Utilisateur page 3

ASSEMBLY INSTRUCTIONS:
Attach the support wheels first.
Note: Do not use the radiator without supporting wheels. Only use the radiator in a vertical
position with the wheels down.
INSTRUCTIONS FOR USE:
Note: Before turning on the radiator, check the power cord. Do not power the radiator in a circuit
with a fuse smaller than 10A.
• Place the radiator on a flat surface to avoid overturning
• Adjust the radiator power by pressing the switch "I" and / or "II":
"I" 1000W, "II" 1500W, "I" + "II" 2500W (+ 400W Turbo)
• Adjust the desired temperature by rotating the thermostat potentiometer
• Activate the Turbo function by pressing the corresponding switch
• If you do not use the radiator, set the "I" and "II" switch to "O" then disconnect it from the socket
Using the timer:
• The radiator will always be switched on if the timer potentiometer is in position "I"
• The radiator will always be turned off if the timer potentiometer is in position "0"
• The radiator will operate according to hourly settings if the timer potentiometer is in position
" ".
• Turn the potentiometer clockwise until the current time is aligned with the indicator "
• When you want to turn on the radiator, push the pin corresponding to a certain time awai from
the center. Each segment has about 15 minutes. For example, if you want the radiator on for
2 hours, push the red pin in 8 neighboring segments.
Power voltage
230V
User manual
Frequency
50Hz 2900W (2500W+400W Turbo)
Maximum power
EN
"
Fins
13
3