Publicité
Les langues disponibles
Les langues disponibles
Operating instructions
USB2.0 Video-Grabber „BR116"
Item no. 1168633
Intended use
The product is intended to be connected to a USB port of a computer for digitising an analogue
AV signal (FBAS/SVideo signal and stereo-audio signal).
This product complies with the applicable national and European requirements. All names of
companies and products are the trademarks of the respective owner. All rights reserved.
Contents
• Video grabber with connection cable
• CD with driver/software
• Operating instructions
Safety Instructions
The warranty will be void in the event of damage caused by failure to observe
these safety instructions! We do not assume any liability for any consequen-
tial damage!
Nor do we assume any liability for material and personal damage caused by
improper use or non-compliance with the safety instructions! In such cases,
the warranty will be null and void.
• The unauthorised conversion and/or modification of the product is not permitted for
safety and approval reasons (CE). Do not open/disassemble!
• The product is not a toy and should be kept out of the reach of children.
• The product must not get damp or wet.
• Do not leave packaging material carelessly lying around, since it could become a
dangerous plaything for children.
• Handle the product with care, it can be damaged by impacts, blows, or accidental
drops, even from a low height.
Software/Drive Installation
First install the driver and the software in the delivery package, do not yet connect
the video grabber!
• Start the operating system (Windows XP or higher) and wait until it is completely loaded.
• Place the enclosed CD in the appropriate drive of your computer.
If the installation program does not start automatically, then load it manually. When these
operating instructions were written, there was a program "Autorun.exe" in the main directory
of the CD. Then install the drive (click on "Install Drivers"). Follow the software's directions.
After the driver installation the software that enables digitalization of the video signal must
be installed. For this, click on "Install VHS to DVD" in the installation program. Follow the
software's directions.
• Now you can close the window for the installation software.
Connection
• First install the driver and the enclosed software; if this has not been done, see previous
chapter.
• Connect the video grabber to a free USB 2.0 port on the computer. The first time it is used,
the computer recognizes Windows' new hardware and completes the installation.
• Start the software.
• Connect an AV source to the 3 RCA jacks (yellow for the video signal, the two others for the
audio signal). Alternatively, the SVideo connection can be used for the video signal and the
red/white RCA jack connectors for the audio signal.
Tips and Information
• Only use a USB 2.0 port otherwise there could be gaps and shakes in the video record.
• Always install the driver first and then the software before the video grabber is connected to
the computer.
• On the CD you will find the English language manufacturer's directions for the software. To
Version 03/15
view this you need a program that can open a PDF file (for example Acrobat Reader, which
°
can be downloaded for free at www.adobe.com).
Disposal
Dispose of the unserviceable product according to the relevant statutory regulations!
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication represent
the technical status at the time of printing.
© Copyright 2015 by Conrad Electronic SE.
Publicité
