EZ Clean AEZ31023 Mode D'emploi

15 in. Surface Cleaner Attachment
AEZ31023
WARNING:
To reduce the risk of injury, user must read and understand
the operator's manual for their pressure washer before us-
ing this accessory. To reduce the risk of injury or property
damage, spray the pressure stream in a safe direction to
ensure proper connection of all accessories before starting
any cleaning project. Fits most pressure washers. Ensure
compatibility and proper fit before using this accessory.
Wear eye protection with side shields marked to comply
with ANSI Z87.1. Risk of fluid injections; do not point at
people, pets, electrical devices or the unit itself. Turn off the
pressure washer before changing or adjusting accessories.
For cold water use only. Save these instructions. Refer to
them frequently and use them to instruct other users. If you
loan someone this tool, loan them these instructions also.
PRODUCT SPECIFICATIONS
Connections ..................................1/4 in. Quick Connect Plug
Deck Width ...................................................................... 15 in.
Maximum Pressure ..................................................... 3300 psi
Maximum Water Flow .....................................................3 gpm
Maximum Water Temperature .........................................140°F
Weight ........................................................................ 4.75 lbs.
INSTALLING THE SURFACE CLEANER ON
THE SPRAY WAND
See Figure 1.
Insert the surface cleaner inlet plug into the spray wand quick
connect coupler and secure.
WARNING:
To reduce the risk of injection or injury, only use the surface
cleaner on flat, horizontal surfaces. Never lift the surface
cleaner from the cleaning surface while operating the pres-
sure washer.
USING THE SURFACE CLEANER
See Figure 2.
n Once the surface cleaner is installed, connect the hose to
the pressure washer as described in your pressure washer
manual.
n Start the pressure washer as described in your pressure
washer manual.
n Walk slowly behind the cleaning deck, cleaning as you go.
NOTE: If striping or swirling occurs, slow your pace. If strip-
ing or swirling continues, the surface cleaner nozzle(s) may
be clogged. See Nozzle Maintenance for how to clean the
nozzles.
INLET
PLUG
WARNING:
Striking any raised obstacle while using the surface cleaner
will damage the unit. If contact does occur and causes
vibration when operating the pressure washer, stop and
discontinue use. Continuing to operate the unit could result
in serious injury or damage to the unit.
NOTE: See figure 3 for the location of the spray bar.
NOZZLE MAINTENANCE
See Figure 3.
When shipped, two nozzles are pre-assembled to the surface
cleaner. These nozzles are appropriate for use with pressure
washers operating at 2300 to 3300 psi with a maximum flow
rate of 3.0 gpm.
QUICK CONNECT
COUPLER
Fig. 1
Fig. 2